I have an aftermarket rear panel on my 68 that was not pre-drilled for the rear license plate mount. From the mounting kit, it looks like it uses the standard plastic square female plug for the bottom and two rubber bumpers for the top? I figured I would just use the license plate as a template, but it might be nice to have a picture of it, dimensions, or both so I don't screw it up. Would someone mind taking a digital pic of the panel without the plate so I can use it as a reference?

Tim, see: /forums/ubbthrea....html#Post56675

Thanks, I searched the forums first, but my criteria must have been wrong. Do the holes for the plastic pieces need to be square? I thought they may be, but from the pic it almost looks like they could be standard circular holes (i.e. just drill em to the right diameter and your done).

I have not yet put the new ones in. The picture on the car is of one of the originals. Here's the view from the end of the GM part: I'm guessing square hole.

I think your right, thanks!

Square holes on the bottom are for inserts. Round holes on the top are for rubber bumpers - 100% certain. Lemme know if you need measurements.

- Jake

Jake, if its not too much trouble I think that would helpful.