I am putting the last few parts of stainless on the 67 vert. I have the window felts in and that was not all that bad. I then put the well molding on and that was not bad either but I have a connection I am not sure of. Where the well molding meets the rear of the window felt of the quarter window, I am not sure if the window felt goes under the well molding or outside of of the molding. It seems to sort of fit when it is under the molding and not so much out side of it. Do I trim the rear of the well molding so they butt up against each other? Help, pictures, what ever you have. Thanks EB
S#$t! just found a picture on the Camaro site. Looks like I have some reworking to do. Should have asked this question earlier today!! Looks like it is a little of both.
