I just put my engine and trans in last weekend and installed my headers after installing them i noticed that they are way too clost to the floor pan the are 1/4" from the floor tops.they a headman huslers for edelbrock heads and i was just wondering if any one else has had a problem with getting them to mate up to the exhaust.the exhaust i'm using is a magna flow 3" stainless exhaust.Also has anyone installed this setup.any info would be great. thanks in advance

Jeremy Wyborney
69 goldenrod yellow hardtop
474 V8,4spd,3.90 8.2"

Wow Jeremy, you are building a monsta! What's that 474, a bored out 455?

thanks fbody,i sure hope it is or the money and time involved was all in vain.Its a bored over 455 with a 4.25 stroke crank,tons of goodies inside.R & S racing in Albert Lea,Mn did all the machine work on the motor.i would recommend them to anyone.

Jeremy

With the 455, it shouldn't be a motor mount height problem.