Anybody got a balancer they can measure the diameter of? I can't find a spare and it's tough while it's on the car. Best I can figure it's 7in. dia. Summit says all Ponts 5 1/4". I don't think so.

Robert

Robert
Its close to 7" the one I measured was 6 13/16"

I just got my new one in...6 3/4" or 6 13/16". I just bought a couple of the soon to be discontinued GM parts.

These guys still have a bunch of NOS ones starting at $9.99.
http://cgi.ebay.com/ebaymotors/68-7...yZ34202QQihZ007QQitemZ170025111327QQrdZ1

Vikki, are the ones you purchased like the ones Jim linked too? (2 piece units.)

Are they the ones you can get from GM Parts Direct that was discussed a week or so ago?

What did you wind up paying for them?

Tim

$33 each after shipping. Yes, they are in fact two piece as original with the rubber internal ring. Finish is black paint, but otherwise they look good. They are Genuine GM parts in GM boxes. They are not cosmetically identical to the original factory issue (casting date pad not present).