Hi, Can anyone give torq. setting on control arm shaft bolt to control arm. Also should I put grease in bushing as I put control arm shaft in ? Thanks

A little grease wouldn't hurt and it may stop a squeak. Here's a good chart when you are in doubt about torque;
http://www.raskcycle.com/techtip/webdoc14.html

Thanks Jim, the reason I ask about this bolt is that it, as u know, is compressing a big rubber afixed to the bushing, smashing it, with a retainer washer so the torque is probly different. I dont know. Thanks

Maybe your bushing hasn't slid up the shaft far enough. It shouldn't be squashing the rubber too much. That bolt needs full torque.

hmm jim... missing something? lol seems like that would be a personal problem to see the doctor about dont you think?!!!