Finally putting the car back together. After 8 years on the rotisserie gathering dust, I just snapped one day pulled it out of the corner and started cutting metal out of it. Been at it non stop every night for 8 weeks. The vert top frame goes on tonight. Then the doors. Then the front fenders. 67 400 vert. Power top Power windows. I have most of that figured out, Will need to know the connections at the fuse box,,, I've searched a bit and found a few pictures that helped, but and having trouble getting the wire harnesses back where they belong. What is the routing for the tail light harness after it transitions from the rocker panel ? This is a vert so I cant remember if it goes up through the vert top bracket or beside it toward the inboard side? Then which side of the trunk braces? The one trunk brace seems to have a hole for a cable stay and I have a stay thats close, but its really tight if I pull it to attach it. Most of the harness "layed" back in place in the rocker both at the front at the kick panel and back .
Regarding the front light harness (brand new original), I found a picture showing the plastic straps across the left inner fender well. The shop manual seems to show it under the fender...I have my old inner fender wells and there are no holes in them for the harness! Rusted originals, and of course no holes in the new ones... I managed to located the cable stay holes across the core support, but am unsure of the routing and connections right at the horn relay-does it come up from the bottom of the inner fender well or down from the top before it turns around the core support?
Could use some help with firewall hole selection. And I have some loose harnesses I cant identify yet. 2,3, & 4 wire small ones. Will get to those later...
I'll post some pictures if I can get them off my phone.
