Been reading the information regarding this tilt column and its great!
I am rebuilding a 68 Tilt Column, this is just the information I was looking for. No one seems to have any info on a tilt column. Have a couple questions hopefully you can assist with. What torque did you tighten the nut using the 22599 socket?
He is wanting to use a billet specialties steering wheel. What I found is they (Billet Specialities) do not make a column adaptor for this type of steering shaft that uses a threaded nut for the upper bearing. Sent them photos and they said they could not assist, they never saw a steering shaft with threads.
He had one of their adaptors 31120 but would jam up on the threads for the upper bearing nut. I had to file down about half of the threads from the shaft so the steering wheel adaptor would fit.
Have a turn signal signal canceling cam button from OER, like the black one pictured in the post. It uses the pin for the horn, and I need to use the wire. This horn button does not have the groove for the horn wire to lock into. What horn button did you use or did you modify the black one for the newer spring wire for the horn button?
