Ok, so I've spent the last couple of days running wires and soldering connections( I'm really slow). Think I've got just about everything hooked up how it's supposed to be. You know those YouTube videos that say, "oh it only take a day to install one of these", yeah, I'd like to see that. Maybe if you had a full electrical supply store on one side and an auto parts store on the other...still. Anyway still have to drill one hole and grommet to run the main power from the battery. Then I have to make sure the cable for the 02 sensor is long enough to reach( iffy ). I may have to buy an extension cable if it doesn't. Once that's done the elect portion of the install will be done. Then I still have to replace the rubber connector hoses between the hard lines at the cross member under the motor, then from the fuel stock fuel pump location up to the unit. Getting there. This would be so much easier with a lift!