When I press the brake the turn signal lights come on both outside and on the dash, but not when I turn on the turn signals.

I installed some of the gauges that go in the clock delete area, I used the ground strap for the clock for ground and the lamp wire to the AM radio for lights for the gauges. They are working fine. Also I purchased the car knowing the lamp lights that light the dash at night where not working. They blew a fuse if you adjusted them up, turned out the PO that restored the car had connected the AM radio lamp wire to the radio ground connector due to both being same color wire. Since the radio didn't work I used it for my new gauges. Now the lamps work.

Also I install new AC hose and the duct work that was left off during the restoration. It was just a few small parts along the bottom. I tried being very careful when sliding the old hose out and installing the new. I hope I didn't disconnect something.