So when I googled it it says there should be a bracket. I honestly can't remember if there was or not and I dint have a oic if that area that shows it. I looked through all my parts and don't have anything that looks like that and don't have anything that I don't remember where it goes. So probably never had it. I took the Solenoid out so I could try to dial it in. Thought if the Solenoid wasn't in I could find the sweet spot of where the pin would jump in and out with little resistance. Tried setting it wuth a wire spacer. I'll attach some pics. When I would get it where is slid onto position I couldn't get it to go back without changing the angle. No matter how smooth it went I'm. Then when I changed the angle to where it would come out the next stroke was off again. I will get some pics of tge surface tomorrow